Cleaning And Servicing; Storage; Troubleshooting - Bosch MUM57B224 Gebrauchsanleitung

Cleaning and servicing

Attention!
Do not use abrasive cleaning agents. Sur-
faces may be damaged.
Cleaning the base unit
W Risk of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.
Cleaning the bowl and tools
The bowl and tools are dishwasher-proof.
Do not wedge plastic parts in the dish-
washer, as they could be permanently
deformed during the washing process!
Cleaning the continuous-feed
shredder
All parts of the continuous-feed shredder
are dishwasher-proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on
a cloth and rub the film off the continu-
ous-feed shredder (not the cutting discs).
Then rinse the continuous-feed shredder.
Cleaning the blender
W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher-proof.
Tip: After processing liquids, it is often suffi-
cient to clean the blender without removing
it from the appliance. Pour a little water and
washing-up liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse out
the blender with clear water.
01_MUM57B224_8001028704.indb 25
Cleaning and servicing
Important information
If required, clean accessories bag. Follow
care instructions in the bag.

Storage

W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Figure L:
■ Store tools and cutting discs in the acces-
sories bag.
■ Keep accessories bag in the bowl.

Troubleshooting

W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Note:
The Operating indicator flashes if the appli-
ance has been operated incorrectly or the
electronic fuse has tripped or the appliance
is defective.
The swivel arm must be engaged in
every operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Troubleshooting
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on as
far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch
appliance to 0/off and then back to the
required setting.
Troubleshooting
Appliance switches off during use. The over-
load protection feature has been activated.
Too much food was processed at one time.
en
25
03.12.2015 14:48:56