Adding More Ingredients - Bosch MUM57B224 Gebrauchsanleitung

en Operation
Attention!
Use bowl with this appliance only.
Professional flexi stirring
whisk (13)
for stirring dough, e.g. cake mixture
Professional beating whisk (14)
for whisking egg whites, cream and
light dough, e.g. sponge mixture
Kneading hook (15)
for kneading heavy dough and mix-
ingin ingredients that ought not be
cut (e.g. raisins and chocolate chips)
Important information concerning the
use of the whisk
Figure E:
The whisk should almost touch the bottom
of the bowl to ensure that the ingredients
are optimally mixed. If not, adjust the height
of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the whisk into the drive until the
whisk locks into position.
■ Hold whisk in place and loosen nut clock-
wise using open-ended wrench (SW 8).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti-clockwise: Lower
■ Press the Release button and
move the swivel arm to
position 1.
■ Check the height of the whisk and, if
required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2.
■ Hold whisk in place and tighten nut
anticlockwise using open-ended wrench
(SW 8).
22
01_MUM57B224_8001028704.indb 22
Working with the bowl and the tools
Figure F:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. E-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Our recommendation:
– P rofessional flexi stirring whisk:
First mix at setting 1-2, then setting 3-5 as
required
– P rofessional beating whisk:
setting 7, mix in at setting 1
– K neading hook:
first stir in at setting 1, knead at setting 3

Adding more ingredients

■ Switch off the appliance with the rotary
switch.
■ Add more ingredients through the feed
tube in the cover.
or
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
03.12.2015 14:48:55