Operation - Bosch MUM50149 Gebrauchsanleitung

en
Operation

Operation

W Risk of injury!
Do not insert mains plug until all preparations
for working with the appliance are complete.
Attention!
Do not operate the appliance without an
accessory/tool in the operating position. Do
not operate the appliance empty. Do not
expose appliance or accessories to heat
sources. Parts are not microwave-safe.
■ Before operating the appliance and acces-
sories for the first time, clean thoroughly;
see "Cleaning and servicing".
Important information
These operating instructions contain a
sticker with reference values for the oper-
ating speed of the appliance when using
the tools or accessories. We recommend
attaching this sticker to the appliance
(Fig. C).
Preparation
■ Place the base unit on a smooth, clean
surface.
■ Pull out the power cord (Fig. D).
Cord store:
Pull out cable to the required
length.
Warning!
Do not twist the cord when inserting it.
■ Insert the mains plug.
Bowl and tools
W Risk of injury from the rotating tools
While the appliance is operating, never place
fingers in the mixing bowl. Attach the cover
(11) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool has
come to a standstill.
For reasons of safety the appliance may only
be operated when unused drives have been
covered with drive guards (4, 7).
22
Attention!
Use bowl with this appliance only.
Stirrer (12)
for stirring dough, e.g. cake mixture
Whisk (13)
for whisking egg whites, cream and
light dough, e.g. sponge mixture
Kneading hook (14)
for kneading heavy dough and
mixingin ingredients that ought not
be cut (e.g. raisins and chocolate
chips)
Working with the bowl and the tools
Fig. E:
■ Press the Release button and
move the swivel arm to position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set
it down. Turn anti-clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. E-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to position 1.
■ Attach the cover.
■ Set the rotary switch to the desired setting.
Our recommendation:
– Stirrer:
first stir in at setting 1, then select setting 4
– Whisk:
setting 4, mix in at setting 1
– Kneading hook:
first stir in at setting 1, knead at setting 2