Notes On Troubleshooting; What To Do If; Support - Ultradent Solaris 2 Gebrauchsanweisung

6 NOTES ON TROUBLESHOOTING
6.1 What to do if...
Audible signals
Error instructions
6.2

Support

Address
Solaris 2 Treatment Light
6 | NOTES ON TROUBLESHOOTING
Function Description
OTP* Beep tone for 30 seconds
MAX 1 beep tone (if the maximum brightness is reached while dimming)
MIN 1 beep tone (if the minimum brightness is reached while dimming)
1 beep tone For control commands
1 beep tone When activating
OpL** Beep tone for 30 seconds
*) OTP: Over­Temperature Protection
**) OpL: No LED supply
Error Cause
Treatment light No power supply
does not switch
on.
If you have any questions concerning the Solaris 2 treatment light, please contact
the customer service staff of your dealer.
GB
Countermeasures
▪ Check that the treatment unit
is switched on.
▪ Check that the dental chair is
in the treatment position.
▪ If necessary, set the switch of
the treatment unit from the
rinsing position/exit position to
the treatment position.
▪ If none of the measures
mentioned above help in
switching on the light, please
contact the customer service
staff of your dealer.
21 of 21