Waeco PerfectView CAM26W Montage- Und Bedienungsanleitung Seite 65

_RV-HD-LCD.book Seite 65 Donnerstag, 14. Dezember 2006 5:03 17
PerfectView
If you would like to attach the camera with threaded screws fitted
through the construction (fig. s, page 12):
Caution!
Ensure that the nuts cannot be pulled through the body shell when
they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera holder on with the M6 x 20 mm threaded screws.
Creating a through-hole for the camera connection cable (fig. t,
page 12)
Note
If possible, use available openings – such as ventilation grilles – to
feed the connection cables through. If there are no existing open-
ings, you must drill a hole with a 20 mm diameter. Check
beforehand that there is sufficient room for the drill head to come
out on the other side.
➤ Drill a hole of Ø 20 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp-edged ducts.
Attaching the camera to the camera holder
➤ Push the camera (fig. 8 6, page 5) into the camera holder (fig. 8 7,
page 5).
➤ Push the camera guard (fig. 8 8, page 5) over the camera holder.
➤ Align the camera so that the lens points downwards on the road.
Caution!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
Installing the reversing video system
65