Waeco PerfectView CAM26W Montage- Und Bedienungsanleitung Seite 62

_RV-HD-LCD.book Seite 62 Donnerstag, 14. Dezember 2006 5:03 17
Installing the reversing video system
The following abbreviations for the colour coding of the connection cables
are used:
br
brown yellow
➤ Insert the system cable plug (fig. 8 9, page 5) into the socket
"CAMERA 1" (fig. c 5, page 7) of the connection box.
➤ Insert the connection cable plug (fig. 8 3, page 5) into the socket
"POWER INPUT" (fig. c 1, page 7) of the connection box.
➤ Connect the connection cable as follows:
– Connect the red cable to terminal 15 (ignition +).
– Connect the black cable to terminal 31 (earth –).
– Connect the orange cable to the positive terminal of the reversing light.
– Connect the white cable to the positive terminal of the instrument
panel illumination.
– Connect the yellow cable to the indicator light.
➤ Lay the system cable under the dashboard.
➤ Connect the camera's connection cable to the extension cable.
➤ Lay the system cable (fig. 8 9, page 5) from the monitor to the site where
you would like to mount the camera.
If required, additional extension cables can be obtained from your dealer or
from WAECO (see chapter "Accessories" on page 50).
➤ Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable straps, insulating tape or glue.
✓ The monitor is ready for use again.
8.3 Installing the connection box
➤ Install the switchbox in a location protected from water near the monitor,
preferably under the dashboard.
Make sure to consider the length of the cable.
➤ Attach the switchbox using the supplied screws. (fig. m, page 10).
Caution!
Make sure there is a good contact. Wrap insulating tape around
every connection on the cable (even inside the vehicle).
62
ge or
orange
rt sw
red black
PerfectView
ws
white