_RV-HD-LCD.book Seite 61 Donnerstag, 14. Dezember 2006 5:03 17
PerfectView
Creating a through-hole for the monitor connection cable (fig. n,
page 10)
Note
Where possible, use available openings, such as ventilation grilles,
panel edges or blank panels to feed the connection cables through.
If there are no existing openings, you must drill a hole with a 13 mm
diameter. Check beforehand that there is sufficient room for the drill
head to come out on the other side.
➤ Drill a hole of Ø 13 mm near the monitor.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp-edged ducts.
Connecting the monitor to the voltage supply
An overview of the reversing video system can be found in fig. w, page 13.
The circuit diagram for the reversing video system can be found in fig. o,
page 11.
No. in fig. o,
page 11
1
2
3
4
5
6
7
8
15
31
Installing the reversing video system
Description
Control box
Switch for the vehicle light
Switch for the reversing light
Ignition socket
Branch connector or soldering point
Indicator
Instrument illumination
Reversing light
Terminal 15 (connected positive terminal)
Terminal 31 (earth)
61