Waeco PerfectView CAM26W Montage- Und Bedienungsanleitung Seite 64

_RV-HD-LCD.book Seite 64 Donnerstag, 14. Dezember 2006 5:03 17
Installing the reversing video system
The most secure type of attachment is with screws fitted through the
body. Please observe the following instructions:
– There must be sufficient space behind the chosen installation location
to be able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through
any holes made (e.g. by using screws and sealant and/or spraying the
outer attachment parts with a sealant).
– The location on the body where you wish to attach the camera must
be rigid enough to allow the camera to be tightly fastened.
Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig. 2, page 4).
If you are not sure about the location you have chosen, ask your vehicle
manufacturer or dealer.
Tip!
We recommend greasing the threads of the bolts to prevent
corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera holder on the chosen location and mark at least two
different points for the drill holes (fig. q, page 12).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig. r,
page 12):
Caution!
Self-tapping screws may only be fastened to steel metal with a
minimum thickness of 1.5 mm.
➤ Drill Ø 5.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the 6 x 20 mm self-tapping screws.
64
PerfectView