Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page GB-22
Fitting and installation
Fitting and installation
Preparation
NOTICE
Risk of damage!
If a trolley is used to move the cook-
■
er set, the appliance must be lifted as
shown on the packaging.
Important user information:
The cooker set has been designed to be
installed in a kitchen unit. If you possess the
required handicraft skills, you can install it
yourself.
However, the electrical installation must be
carried out by an authorised professional.
Installation requirements
– Do not install the oven directly next to a
refrigerator or freezer. This will increase its
energy consumption unnecessarily due to
heat emission.
– The best place is next to the sink. You have
an additional storage surface and dirty
crockery can be cleaned immediately.
– Prior to installation, check whether the
appliance dimensions are compatible with
your kitchen recess dimensions.
– In respect of fire protection, the oven
conforms to Type Y (EC 335-2-6). This
type of appliance may only be installed on
one side of taller kitchen cabinets, appli-
ances or walls.
– The installation recess may not have a rear
panel, at the most it may have an add-on
edge measuring no more than 50 mm.
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with ventilation cut-out.
– Your built-in furniture may need to be modi-
fied. If you do not have the manual skills to
do this, you should hire a professional.
– Veneers or plastic coverings on the built-in
furniture require heat-resistant adhesive
(100 °C). If the adhesive and surfaces are
not heat-resistant, the covering may warp
and come loose.
– An intermediate shelf is required if a drawer
is to be installed below the oven.
– The installation recess and the cut-away
area in the worktop must have the following
dimensions (details in mm):
560
The minimum installation recess must
also take account of the connection
socket, otherwise it won't be possible to
push the oven in completely.
– The hob and oven are connected by the
permanently installed wiring harness; they
must therefore be installed directly above
one another.
560
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
