Start-Up; To Dismantle The Cooker - hanseatic 65C40C1-E11B04A Gebrauchsanleitung

Start-up

1. If you have not yet done so, remove all
transportation safety materials (cardboard
strips etc.) and all adhesive strips/films
from the oven and hob.
2. Turn all the cooker's dials to '0'.
3. Switch on the fuses for the cooker's elec-
trical circuit.
4. Switch the cooking zone and the oven on
briefly in order to check the functionality.
Pre-cleaning the oven
The oven must be pre-cleaned to remove all
grease and oil residues from the manufac-
turing process, as well as tough dust deposits
left over from storage and transportation. This
not only helps protect your health but also
ensures delicious cakes and roasts.
1. In order to do so, operate the oven for
approximately 1 hour at a top/bottom heat
of 250 °C. Leave the oven rack, baking
tray and dripping pan in the oven in order
to do so.
2. Let all parts dry completely afterwards.
3. Wash the oven rack, baking tray, dripping
pan and cooking compartment with clean
water. Then dry everything off.
You will find all important information about
operation from page GB-14.
Fitting and installation

To dismantle the cooker

WARNING
Electric shock / fi re hazard!
First switch off the circuit breakers or
unscrew the fuses for the cooker's elec-
trical circuit.
1. Remove both of the fastening screws
behind the oven door.
2. Lift the oven up slightly and pull it out until
the sockets of the hob are accessible. Do
not pull on the handle of the oven door!
3. Pull the hob cable plug out of the bush-
ings on the oven.
4. Lift the oven out of the built-in cabinet
– while taking care not to damage the
mains cable.
5. Remove the 4 retaining clips from the
hob.
6. Push the hob upwards and outwards with
care.
7. Have the oven disconnected by an elec-
trical installation technician.
Page GB-27