Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Switching on and off
Switching on:
♦
To start the appliance, press the ON/OFF
switch
and keep it pressed in.
The LED work light
OFF switch
is depressed lightly or fully. This
allows for illumination of the work area in low
lighting.
Switching off:
♦
Release the ON/OFF switch
the appliance.
Adjusting the rotational speed
The ON/OFF switch
control. Pressing the ON/OFF switch
yields a low speed. Increasing pressure increases
the speed.
NOTE
►
The integrated motor brake ensures rapid
stoppage.
Changing the direction of rotation
♦
Change the direction of rotation by pressing the
rotational direction switch
or right.
PABS 16 A2
lights up when the ON/
to switch off
has a variable speed
lightly
towards the left
Tips and tricks
Tip! This symbol indicates proper
behaviour.
♦
Before operating the appliance, check whether
the screw or drill bit is correctly positioned, i.e.
centred in the drill chuck.
♦
Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check whether the bit fits tightly in the
screw head without any free play.
Torque:
♦
Smaller screws/bits can be damaged if you set
the torque or rotational speed too high.
Hard screw joints (in metal):
♦
Particularly high torques occur, for example, in
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood):
♦
Again, use a low rotational speed, e.g. to avoid
damaging the surface of the wood upon con-
tact with the screw head. Use a countersink.
When drilling in wood, metal and other
materials, observe the following:
♦
Use a high speed for drill bits with small
diameter and a low speed for drill bits with
large diameter.
♦
Select a low speed for hard materials and a
high speed for soft materials.
♦
Secure or fasten the workpiece in a clamp or
vice (if possible).
♦
Mark the spot where you want to drill using a
centre punch or nail. Select a low rotational
speed when starting.
♦
Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
GB
19
■
│
Werbung
Kapitel
Inhaltsverzeichnis
