CLIVET MKG-V250 Installations- Und Bedienungsanleitung Seite 54

MODE: Once pressing, running mode will be selected in
the following sequence:
AUTO COOL
NOTE: No heating mode for cool only type unit.
FAN SPEED: Fan speed will be selected in following
sequence once pressing this button:
AUTO LOW MED
Adjust : Decrease the set temp. Keeping pressing will
decrease the temp with 1
Adjust Increase the set temp. Keeping pressing will
increase the temp with 1
ON/OFF: For turning on or turning off the air conditioner.
AIR DIRECTION: Activate swing function of air deflector. Once
pressing, air deflector will turn 6 . For normal operation and
better cooling and heating effect, deflector will not turn to the
degree which is the state of deflector when the unit is turned
off.( Only available when remote controller is used with
corresponding unit.)
Wind Vert Swing: Activate or turn off wind vertical swing
function. (Only available when remote controller is used
with corresponding unit.)
Wind Horiz Swing: Activate or turn off wind horizontal
swing function. (Only available when remote controller
is used with corresponding unit.)
CLOCK: Display the current time. (12:00 is displayed when
resetting or electrifying for the first time.) Press CLOCK for
5s, icon indicating hour will flash with 0.5s. Press it again,
icon indicating minute will flash with 0.5s.
3
BUTTONS AND THEIR FUNCTIONS
DRY HEAT FAN
HIGH
per 0.5s.
per 0.5s.
and are used
to adjust the figure. Setting or modification is effective only
by pressing OK button to make confirmation.
TIME ON: For time ON setting. Once pressing this button,
the time will increase by 0.5 hour. When the set time exceeds
10 hours, pressing the button will increase the time by 1 hour.
Adjusting the figure to 0.00 will cancel time ON setting.
TIME OFF: For time OFF setting. Once pressing this button,
11
the time will increase by 0.5 hour. When the set time exceeds
10 hours, pressing the button will increase the time by 1 hour.
Adjust the figure to 0.00 will cancel time ON setting.
RESET (inner located): Press this button with a needle of
12
1mm to cancel the current setting and reset remote controller.
LOCK (inner located): Press this button with a needle of
13
1mm to lock or unlock the current setting.
OK: Used to confirm the time setting and modification.
14
COOL/HEAT (inner located): Press this button with a needle
15
of 1mm to shift mode between COOL only and COOL&HEAT.
During setting, back light will be lightened. Factory default
mode is COOL &HEAT.
ECO: Activate or turn off economic operation mode. It is
16
suggested to turn on this function when sleeping. (Only
available when remote controller is used with corresponding
unit.)
4
BUTTONS AND THEIR FUNCTIONS