Transferring Data To A Computer - Leica T Anleitung

EN TRANSFERRING DATA TO A COMPUTER USING THE USB
CONNECTION
The Leica T is compatible with the following operating systems:
Microsoft : Windows
®
Apple Macintosh : Mac
® ®
The camera is equipped with a high-speed USB 2.0 interface for
transferring data.
Using the camera as an external drive
With Windows operating systems:
The operating system detects the camera as an external drive and
assigns it a drive letter. Transfer the picture data to your computer
using Windows Explorer and save it.
With Mac operating systems:
The camera appears as a storage medium on the desktop. Transfer
the picture data to your computer using Finder and save it.
200
XP / Vista / 7 / 8
® ® ® ®
OS X (10.6) and later
®
Important:
• Only use the USB cable supplied.
• While data is being transferred, the USB cable must not be
disconnected as otherwise the computer and/or the camera
may crash. This could cause irreparable damage to the memory
card.
• The camera must not be turned off or automatically shut itself
down due to a lack of battery power while data is being
transferred, as this can cause the computer to crash.
• For the same reason the battery must never be removed from
the camera whilst the connection is active. If the battery
capacity deteriorates while data is being transferred, the INFO
screen appears with the battery capacity flashing. In this case,
stop the data transfer, turn off the camera and charge the
battery.
Transferring data to a computer using a card reader
Picture data can also be transferred using card readers for SD/
SDHC/SDXC memory cards. Compatible external card readers are
available for computers with a USB interface.
Note:
The Leica T is equipped with an integral sensor which detects the
position of the camera – horizontal or vertical (both directions) –
for each picture. This information allows the pictures to always be
automatically displayed upright when subsequently displayed on a
computer running the appropriate programs.