Technical Data; Noise And Vibration - Ferm AGM1053 Übersetzung Der Orginalbetriebsanleitung

following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
- The wire which is coloured brown must be
connected to the terminal which is marked with

TECHNICAL DATA

Power input
Grinding disc
Bore

NOISE AND VIBRATION

)
pa
)
wa
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
- the times when the tool is switched off or when
it is running but not actually doing the job, may
Ferm
Your angle grinder has been designed for grinding
and cutting masonry and steel.
2. Spindle lock button
6. Auxiliary grip
AGM1053
ASSEMBLY
W 880
11,000
-1
mm 22
Mounting
AGM1053
dB(A) 89
dB(A) 100
2
2
1.5
2
tightening the screw (11) and the nut (12).
Removing
(11) and the nut (12).
Before assembly, always switch off the
machine and remove the mains plug
Do not use the machine without the
EN
7