Inhaltsverzeichnis
Werbung
The wires in the mains cable are coloured in
accordance with the following code:
blue
neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
-
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
-
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
tECHNICAL DAtA
Mains voltage
Mains frequency
Power input
No-load speed
Grinding disc
Diameter
Bore
Spindle thread
Weight
NOISE AND VIBRAtION
Sound pressure (L
)
pa
Acoustic power (L
)
wa
Uncertainty (K)
Vibration (main grip)
Vibration (auxiliary grip)
Uncertainty (K)
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
-
using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
-
the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm, and
organizing your work patterns
Wear hearing protection.
Description (fig. a)
Your angle grinder has been designed for grinding
and cutting masonry and steel.
1. On/off switch
2. Spindle lock button
3. Spindle
4. Guard
5. Main grip
6. Auxiliary grip
AGM1045
V~ 230
ASSEMBLy
Hz 50
W 880
min
11,000
-1
mm 125
Mounting and removing the guard (fig. B)
mm 22
M14
kg 2.34
Mounting
● Place the machine on a table with the spindle
AGM1045
(3) facing upwards.
dB(A) 89
● Keep the spindle lock button (2) pressed and
dB(A) 100
remove the flange (7) using the flange key (8).
dB(A) 3
● If necessary, remove the grinding disc (9).
m/s
7.3
2
● Remove the flange (10).
m/s
13.8
2
● Mount the guard.
m/s
1.5
2
● Mount the flange (10).
● If necessary, mount the grinding disc (9).
● Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Removing
● Place the machine on a table with the spindle
(3) facing upwards.
● Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
● If necessary, remove the grinding disc (9).
● Remove the flange (10).
● Remove the guard.
● Mount the flange (10).
● If necessary, mount the grinding disc (9).
● Keep the spindle lock button (2) pressed and
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Do not use the machine without the
guard.
7
Werbung
Inhaltsverzeichnis
