Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data; Noise And Vibration - Ferm ECONOMY PSM1025 Bersetzung Der Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that
it is correctly destroyed and replaced by an
approved BS 1363/3A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue
neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
-
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
-
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Protection class
Weight

NOISE AND VIBRATION

Sound pressure (L
)
pa
Acoustic power (L
)
wa
Uncertainty (K)
Vibration
Uncertainty (K)
2
Wear hearing protection.
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
60745; it may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
6
-
using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
-
the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPtION (FIG. A)
Your finishing sander has been designed for
sanding wood, metal, plastics and painted
surfaces.
1. On/off switch
2. Lock-on button
3. Sanding pad
4. Sanding paper clamp
5. Main grip
6. Auxiliary grip
7. Dust extraction connection
PSM1025
ASSEMBLy
V~ 230
4
Hz 50
W 135
min
10,000
-1
IP 20
Mounting and removing the sanding paper
kg 1.3
(fig. B)
Mounting
PSM1025
● Open the sanding paper clamps (4).
● Mount sanding paper (8) with the required
dB(A) 73
grain size onto the sanding pad (3). Make sure
dB(A) 84
that the perforation in the sanding paper (8)
dB(A) 3
corresponds with the perforation on the sanding
m/s
12.11
2
pad (3).
m/s
1.5
2
- Use coarse sanding paper (grain 50) for
- Use medium sanding paper (grain 80) for
- Use fine sanding paper (grain 120) for
● Fold the sanding paper (8) at both ends
around the edges of the sanding pad (3).
● Close the sanding paper clamps (4) one by
one. Make sure that the ends of the sanding
paper (8) are clamped.
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
sanding rough, uneven surfaces.
removing the remaining scratches from the
coarse sanding paper.
finishing surfaces.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis