Electrical Safety; Technical Data; Noise And Vibration - Ferm AGM1038 Bedienungsanleitung

Winkelschleifer

Seite von 129

/ 129
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

● Keep bystanders away from the work area.

Make sure that all persons in the work area

wear protective equipment. Risk of personal

injury.

● Hold the machine by the insulated gripping

surfaces where the grinding disc may contact

hidden wiring. If the grinding disc contacts

a ‚live' wire, the exposed metal parts of the

machine can also become ‚live'.

Risk of electric shock.

● Do not use the machine while carrying it at

your side. Risk of personal injury.

● Do not use the machine on workpieces

requiring a maximum grinding depth that

exceeds the maximum grinding depth of the

grinding disc.

● Do not use accessories that require liquid

coolants. Risk of electric shock.

● Do not use the machine near flammable

materials. Risk of fire.

● Do not work materials containing asbestos.

Asbestos is considered carcinogenic.

● Do not work metal with a magnesium content

of more than 80%.

● Beware that the grinding disc continues to

rotate for a short period after switching off the

machine. Do not attempt to bring the grinding

disc to a standstill yourself.

● Never put the machine down on a table or

a workbench before it has been switched off.

● Regularly clean the ventilation slots.

Risk of electric shock.

Kickback is a sudden reaction to a pinched,

bound or twisted grinding disc, which causes the

machine to lift up and out of the workpiece

towards the user. If the grinding disc is pinched

or bound tightly by the cut, the grinding disc jams

and the machine is rapidly driven back towards

the user. If the grinding disc is twisted in the cut,

the back edge of the grinding disc can dig into the

top surface of the workpiece, which causes the

grinding disc to climb out of the cut and jump

back towards the user.

Kickback is the result of incorrect use of the

machine and/or incorrect operating procedures

or conditions. Kickback can be avoided by taking

proper precautions:

● Firmly hold the machine with both hands.

Position your arms to resist kickback forces.

Position your body to either side of the grinding

disc, but not in line with the grinding disc.

Kickback can cause the grinding disc to jump

backwards. If proper precautions are taken,

kickback forces can be controlled by the user.

● Be extra careful when using the machine on

corners, sharp edges, etc. Make sure that the

grinding disc does not become jammed. Risk

of kickback.

● If the grinding disc jams or if you interrupt a cut

for any reason, release the on/off switch and

hold the machine motionless in the material

until the grinding disc comes to a complete

standstill. Never attempt to remove the machine

from the workpiece or pull the machine

backward while the grinding disc is in motion.

Risk of kickback.

● Do not use blunt or damaged grinding discs.

Unsharpened or incorrectly mounted grinding

discs produce narrow cuts, which causes

excessive friction and kickback and increases

the risk of the grinding discs becoming

jammed.

● Do not use toothed saw blades. Do not use

woodcarving blades for saw chains.

Risk of personal injury.