Electrical Safety; Machine Information; Technical Specifications - Ferm AGM1116P Bersetzung Der Originalbetriebsanleitung

Electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.

2. MACHINE INFORMATION

Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard
must be used (not included) Fig. D2.

Technical specifications

Mains voltage
Mains frequency
Power input
Rated speed
Wheel disc for grinding
Diameter
Bore
Thickness
Wheel disc for cutting
Diameter
Bore
Thickness
Spindle thread
Weight
Sound pressure (L )
PA
8
AGM1116P AGM1118P
220-240 V~
50/60 Hz
2300W
8.500 /min 6.500 /min
180 mm 230 mm
22.2 mm
6 mm
180 mm 230 mm
22.2 mm
3 mm
M14
6.0 kg 6.1 kg
96 + 3 dB(A)
Acoustic power (L )
WA
Vibration "Surface grinding"
a
h,AG
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-4
Fig. A
1. Spindle lock button
2. Allen screw
3. Protection guard (Fig. D1+D2)
4. Carbon brush cover
5. On/Off switch
6. Side handle connection point
7. Side handle
8. Allen key
9. Rear handle
10. Handle release knob
Fig. B
11. Spindle
12. Mounting flange
13. Wheel disc (not included)
14. Clamping nut
15. Spanner
Fig. C1 & D1
Protection guard for grinding
107 + 3 dB(A)
9.81 + 1.5 m/s2