Yamaha YZ250LC Fahrer- Und Wartungshandbuch Seite 448

HANDLEBAR
2. Install:
9 Grip cap (upper) 1
9 Grip cap (lower) 2
9 Bolt (grip cap) 3
NOTE:
Temporarily tighten the bolts (grip cap).
EC5B5210
Handlebar
1. Install:
9 Handlebar 1
9 Handlebar holder 2
9 Bolt (handlebar holder) 3
NOTE:
9 The upper handlebar holder should be installed
with the punched mark a forward.
9 First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts on
the rear side.
2. Install:
9 Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
9 Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
9 Install the grip (left) to the handlebar so that the
line b between the two arrow marks faces
straight upward.
3. Install:
9 Collar 1
9 Cap cover 2
9 Throttle 3
NOTE:
9 Apply the lithium soap base grease on the
throttle grip sliding surface.
9 Tighten the grip cap bolts temporarily without the
throttle being fixed to the handlebar.
5-42
CHAS
28 Nm (2.8 m•kg, 20 ft•lb)