Yamaha YZ250LC Fahrer- Und Wartungshandbuch Seite 120

1 Radiator breather hose
2 Ground lead
3 Clamp
4 Wireharness
5 High tension cord
6 Ignition coil
7 Throttle cable
8 "ENGINE STOP" button lead
9 Clutch cable
0 Engine bracket
CABLE ROUTING DIAGRAM
A Clamp the clutch cable, high
tension cord and wireharness at
the protector of the high tension
cord so that the clamp passes
with its ends downward, as
shown.
B Position the CDI magneto lead
coupler between the radiators.
C Install the radiator hose with the
paint facing the right of the frame
so that the hose does not come
in contact with the CDI unit.
D Clamp the wireharness to the
right engine bracket.
E Clamp the high tension cord,
throttle cable and wireharness
with the clamp ends downward,
so that the high tension cord
does not contact the engine
bracket installation bolts.
2-15
SPEC
F Fasten the ground lead together
with the front installation portion
of the ignition coil.
G Pass the radiator breather hose
at the rear of the radiator hose
and in front of the ignition coil
bracket.
H
Position each lead at the lower
left of the main tube (frame)
and put the clamp ends within
the area as shown by the
arrow.