Maintenance - Simplicity P1628EX Bedienungsanleitung

MAINTENANCE

PROCEDURE
Check to Make Sure
Auger Blade Stops Within
5 Seconds After Right
SAFETY
Control Lever is Released
Lubricate Control Levers
and Linkages
Check Snowthrower for
Loose Hardware
Lubricate Hex Shaft and
Chains
Lubricate Auger Shaft
Fittings
Lubricate Chute Rotation
SNOWTHROWER
Gear and Deflector
Mechanism
Remove All Snow and
Slush off Snowthrower to
Prevent Freezing of Auger
or Controls
Check Tire Pressure
Oil, Check
Oil, Change
ENGINE
Check and Replace Spark
Plug
NOTE: The warranty on this snowthrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snowthrower as instructed in this manual.
The above Service Recom mendations are supplied to assist the
operator to properly maintain the snowthrower.
24
SERVICE RECOMMENDATIONS
FIRST BEFORE AFTER
5 EACH EACH
HOURS USE USE
✓
✓
✓
✓
✓
NOTICE: If grease or oil comes into contact with the disc drive
plate or friction wheel, make sure to clean plate and wheel
thoroughly with an alcohol base solvent.
EVERY EVERY EVERY
5 10 25
HOURS HOURS HOURS
✓
✓
✓
✓
✓
✓
✓
CAUTION: Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate. If the disc
drive plate or friction wheel come in contact with
grease or oil damage to rubber friction wheel will
result.
BEGINNING
BEFORE
EACH
STORAGE
SEASON
✓
✓
✓ ✓
✓
✓
✓
✓
www.simplicitymfg.com