Simplicity P1628EX Bedienungsanleitung Seite 21

WARNING: Never run engine indoors or in an enclosed,
poor ventilated area. Engine exhaust contains CARBON
MONOXIDE, an ODORLESS and DEADLY GAS.
• Keep hands, feet, hair, and loose clothing away
from any moving parts on engine and snow-
thrower.
• Temperature of muffler and nearby areas can
exceed 150°F (66°C). Avoid these areas.
• DO NOT allow children or young teenagers to
operate or be near snowthrower while it is
operating.
WARNING: Read Operator's Manual before operating
machine. This machine can be dangerous if used
carelessly.
• Never operate the snowthrower without all guards,
covers, shields in place.
• Never direct discharge towards windows or allow
bystanders near machine while engine is
running.
• Stop the engine whenever leaving the operating
position.
• Disconnect spark plug before unclogging the
impeller housing or the discharge chute and
before making repairs or adjustments.
• When leaving the machine, remove the safety key.
To reduce the risk of fire, keep the machine clean
and free from spilled gas, oil, and debris.
TM
EASY-TURN TRACTION CONTROL
For easy turning when using the snowthrower, squeeze the Easy-Turn
lever (see Figure 8).
TM
Engaging the Easy-Turn lever releases the left traction wheel, but allows
the right wheel to continue driving. Releasing the Easy-Turn
matically engages both drive wheels for full traction (see Figure 9).
NOTE: The Easy-Turn TM will be more difficult to activate under a
heavy load. Activate the lever before beginning a turn.
DISCHARGE CHUTE, DEFLECTOR, AND GRIP
WARMER
Discharge Chute Rotation (Left/Right)
1. Press the chute rotation switch to the UP/DOWN position and hold to
rotate the chute to the left or right (A A , Figure 10).
2. After the desired position is obtained, release the switch to the CEN-
TER position to turn off.
Chute Deflector (Up/ Down)
1. Press the chute deflector switch to the UP position and hold to provide
a higher stream and greater distance (B B , Figure 10).
2. Press the switch to the DOWN position and hold to provide a lower
stream and less distance.
3. After the desired position is obtained, release the switch to the CEN-
TER position to turn off.
Grip Warmer (High/Low)
1. Press the grip warmer switch to the LEFT position for the HIGH setting
(see Figure 11).
2. Press the switch to the RIGHT position for the LOW setting.
3. Move the switch to the CENTER position to turn the grip warmer OFF.
CHECK THE OIL (BEFORE STARTING ENGINE)
NOTE: The engine was shipped from the factory filled with oil.
Check the level of the oil. Add oil as needed.
1. Make sure the unit is level. Use a high quality detergent oil classified
"For Service SF, SH, SJ, SL, or higher".
2. Remove the oil fill cap/dipstick (A A , Figure 12) and wipe with a clean cloth.
3. Insert the oil fill cap/dipstick and turn clockwise to tighten.
4. Remove the oil fill cap/dipstick and check the oil.
NOTE: Do not check the level of the oil while the engine runs.
5. If necessary, add oil until the oil reaches the FULL mark on the oil fill
cap/dipstick. Do not add too much oil.
6. Tighten the oil fill cap/dipstick securely each time you check the oil
level.
NOTE: Synthetic 5W30 motor oil is acceptable for all
TM
temperatures. DO NOT mix oil with gasoline. See Chart for oil
recommendations.
TM lever auto-
* Below 40°F (4°C) the use of SAE 30 will result in hard starting.
** Above 80°F (27°C) the use of 10W-30 may cause increased oil consumption. Check oil
level more frequently.
OPERATION
21