Setting The Light Operating Mode; Activating/Deactivating The Foil Sensor; Status Output - Sentiotec just sauna fin Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

8.5. Setting the light operating mode

The light for the sauna room can either be dimmed or switched on and off. The
dimmer function is activated or deactivated using the function selection switch 5.
● The function selection switch 5 is set to the ON position as standard. The
dimmer function is therefore activated.
● If you wish to deactivate the dimmer function for the sauna room light, place
the function selection switch 5 in the OFF position.

8.6. Activating/deactivating the foil sensor

If infrared heat plates are connected to an additional output, a foil sensor must
be used. The foil sensor must be activated with the aid of the function selection
switch 6.
● The function selection switch 6 is set to the OFF position as standard. The
foil sensor is therefore deactivated.
● If you wish to activate the foil sensor, place the function selection switch 6 in
the ON position.

8.7. Status output

The status output function is activated or deactivated using the function selec-
tion switch 7.
● The function selection switch 7 is set to the OFF position as standard. The
status output is therefore activated.
● If you wish to deactivate the status output, place the function selection switch
7 in the ON position.
WORLD OF WELLNESS
p. 29/44
EN