Sensor Operating Modes - Sentiotec just sauna fin Montage- Und Gebrauchsanweisung

Instructions for installation and use p. 11/44
heater off at a temperature of approx. 139 °C.

3.4. Sensor operating modes

The sauna control unit can be operated with one or two temperature sensors.
Single-sensor mode (F1)
Single-sensor mode must be activated when starting up the sauna for the fi rst
time (see 8.2. Activating single-sensor mode on page 27).
In single-sensor mode, the sauna control unit is operated with the heater sensor
with an excess temperature fuse (F1) only. In single-sensor mode, the sauna control
unit only displays the set temperature. The actual temperature is not displayed.
Two-sensor mode with bench sensor (F2)
The second temperature sensor is installed above the rear sauna bench (bench
sensor). In two-sensor mode, the sauna control unit displays the temperature
measured by the bench sensor as the actual temperature.
EN
WORLD OF WELLNESS