Siemens SINUMERIK 840D sl Inbetriebnahmehandbuch Seite 273

08/2005
Registerkarte: Advanced
Systemparameter
Installed O/S
Reset Configuration Data
Legacy USB Support
USB controller restart
I/O Device Configuration
Internal COM 1
Base I/O address
Interrupt
PCI-Configuration
PCI Device Slot 1
Option ROM Scan
Enable Master
Latency timer
PCI Device Slot 2
Option ROM Scan
Enable Master
Latency timer
SATA/PATA Configuration
PATA Controller
SATA Controller mode
AHCI Configuration
RAID support
Registerkarte: Security
Systemparameter
Supervisor Password Is
User Password Is
Set User Password
Set Supervisor Password
Password on boot
Fixed disk boot sector
© Siemens AG 2005 All Rights Reserved
SINUMERIK 840D sl/840D/840Di/810D IBN Basesoftware (IAM2) - Ausgabe 08/2005
Inbetriebnahme PCU-Basesoftware (IM8)
Standardeinstellungen
Other
No
Disabled
Enabled
Enabled
3F8
IRQ 4
Enabled
Enabled
Default
Enabled
Enabled
Default
Enabled
Enhanced
Disabled
Disabled
Standardeinstellungen
Disabled
Disabled
Enter
Enter
Disabled
Normal
1 System inbetriebnehmen
Eigene Eintragungen
Eigene Eintragungen
IM8/1-11