Changing Batteries - Cochlear Baha BP100 Bedienungsanleitung

Weekly care
Clean the inside of the abutment on a weekly basis,
using the cleaning brush as described previously.
If you use the abutment cover make sure it is
cleaned at least once a week. Use warm soap and
water and your soft brush to clean the cover.
Long-term care
You will have regular check-ups as determined by
your hearing health care professional. These check-
ups help ensure that the processor works and fits
properly and that your implant area is healthy.
20

Changing batteries

When there is approximately one hour of remaining
battery power, two beeps/flashes occur three times to
let you know that soon the battery will need replacing.
At this time you may experience low amplification.
If the battery runs down completely, the sound
processor will beep/flash and then stop working.
Use one of the included batteries (zinc-air,
type 13, non-rechargeable) as a replacement. The
batteries included in the sound processor kit reflect
Cochlear's latest recommendations. Contact your
hearing care professional for additional batteries.
To replace the battery:
1 Gently slide the battery door downwards until
2
you feel a 'click'. You can now remove the door.
3 With a fingernail, gently lift the battery hatch
open to expose the battery.
4
Remove the old battery. Use the included
magnetic removal tool if needed. Dispose of
battery according to local regulations.
1 2 3
5
4 6
5 Remove the sticker on the + side of the new
battery. Insert the new battery with the + sign
facing the + marked on the processor's battery
compartment.
6 Gently press the battery hatch closed.
7 Attach the battery door and slide it gently back
into its locked position.
English
7
21