Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-16
Assembly
Attaching the exhaust hood
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to property damage.
When lifting and carrying the ex-
■
haust hood, always carry it by the
housing and never by the glass cover!
This could otherwise break.
1. Screw four mounting rails (2) to the ex-
haust hood (1) using four screws (8) in
each case.
2. Screw the other four mounting rails (2)
with four screws (8), four washers (10)
and four nuts (9) to the previously at-
tached mounting rails in such a way
that the exhaust hood sits at the desired
height later on.
Please note! The upper mounting rails
must protrude by at least one hole width
over the mounting rails, so that they can
be attached to the base plate (6) later on.
(2)
(13)
(8)
3. Only for exhaust air operation:
Carefully insert both plastic check valves
(13) into the air outlet opening at the top
of the appliance (gently bend the flaps a
(1)
little so as not to break off the sensitive
plastic tabs).
Attach the exhaust air hose (5) opening
with a diameter of 153 mm (see marking
(2)
(8)
(10)
(9)
(5)
(11)
Werbung
Kapitel
Inhaltsverzeichnis
