hanseatic SY-3288AIS-E3-C40-L14-900 Gebrauchsanleitung Seite 41

on the hose) to the vent opening and se-
cure it with cable ties (11).
(4)
4. Remove the protective foil from the upper
part of the flue screen (3) and carefully
insert it into the lower section of the flue
screen (4).
Please note! The parts are not square. If
the upper section does not fit, turn it by a
quarter turn.
5. Place the assembled flue screen (3)+(4)
over the mounting rails (2) above the ex-
haust hood. The end with the ventilation
slots in the upper section (3) must be
facing upwards. The flue screen must fit
exactly into the recess of the glass hood
(quarter turn as required)
6. Remove any remaining blue protective
film from the flue screen.
(6)
(11)
7. Lift the exhaust hood with two people by
holding onto the housing, and hold it to
the base plate (6) at the top and screw
the mounting rails (2) to the base plate
using four screws (8), four washers (10)
and four nuts (9).
8. For exhaust air operation: Attach the ex-
haust air hose opening with a diameter of
(2)
150 mm (see marking on the hose) to the
vent opening in the ceiling and secure it
with a cable tie (11).
9. Connect the power supply.
(8)
( ( ( (10)
(9)
Page EN-17
Assembly