Silvercrest SMRB 40 A1 Bedienungsanleitung Seite 51

 Use 2 of the screws supplied (G,
arrows) to mount the wall mounts (E)
to the two gaps on the back of the
sound bar. To do this, insert the
Philips screwdriver through the gap in
the wall mount. The small round-
shaped part of the gap should point
upwards.
 Use the drilling template included and mark the drill holes on the wall. Use the spirit level to
mark the holes at the same height.
 Depending on the wall, next drill the required holes for the screws/rawlplugs. Insert the screws
and twist them until the screw head is approx. 3 to 4 mm away from the wall.
2 adhesive foam pads (F) are included in the package.
They are self-adhesive and will protect the wall where
you want to mount the sound bar. Break and remove the
stamped-out inner part of the foam pad (F). This inner
part is no longer needed. Remove the film from the back
and stick the foam pad (F) to the wall mounts you have
already fitted so that the gap is not covered and the
foam part of the adhesive pad touches the wall when the
sound bar is hung on the wall.
 Next place the sound bar with the two wall mounts fitted to the 2 screw heads that are slightly
away from the wall.
1. Centre and press.
2. Firmly press the sound bar downwards until the 2 screw heads are seated behind the round-
shaped part of the gap.
Check that the sound bar is firmly fitted to both screws. If necessary, repeat the process. It may be
necessary to rotate the screws clockwise or anticlockwise a little.
SilverCrest SMRB 40 A1
English - 49