Silvercrest SMRB 40 A1 Bedienungsanleitung Seite 47


The power adapter consumes electricity even in Standby mode. In order to completely
disconnect the device from the mains, the power adapter must be pulled out from the power
socket.
Please follow these instructions to avoid risk of potential fatal injury or fire! Never cover the power
adapter, otherwise there is a risk of fire. Do not attempt to open the housing of the power adapter.
This could result in potentially fatal electrocution.
WARNING! Cables
Unplug all cables by holding the plugs and never pull on the cables themselves. Never place
pieces of furniture or other heavy objects on the cables and take care that they do not become
damaged, especially at the plugs and sockets. Never install the cables around hot or sharp objects
to avoid damaging them. Never tie knots in cables and do not tie them to other cables. All cables
should be positioned so that nobody can trip over them or be obstructed by them.
DANGER! Radio interface
Turn the device off when on board an aircraft, in a hospital, in an operating theatre or in the vicinity
of electronic medical equipment. The RF signals may interfere with the functionality of sensitive
devices. Keep the device at least 20 cm (8 inches) away from pacemakers, as the RF signals could
interfere with the functionality of the pacemaker. The RF signals transmitted can interfere with
hearing aids. If the wireless mode is switched on, do not place the device near flammable gases or
in a potentially explosive area (e.g. a paint shop), as the RF signals transmitted could cause
explosions or fire. The range of the radio frequency signals depends on environmental conditions. If
data is transmitted via a wireless connection, it can also be received by unauthorised parties. Targa
GmbH is not liable for any interference caused to RF or TV signals through unauthorised
modification to this device. Furthermore, Targa accepts no liability for replacing any cables or
devices that have not been specifically approved by Targa GmbH. The user is solely responsible
and liable for remedying any interference caused by such unauthorised modification of this device
and for replacing appliances.
Servicing / Repair
Repairs are required if this device is damaged in any way, for example, if the power adapter or
device housing is damaged, if liquids or objects have entered the device or if the product has been
exposed to rain or moisture. Repairs are also necessary if the product is not working properly or
has been dropped. If you notice any smoke, unusual noise or strange smells, switch off the device
immediately and pull the power adapter out of the power socket. If this occurs, do not continue to
use the device and have it checked out by an expert. All repairs must be carried out by qualified
service personnel.
SilverCrest SMRB 40 A1
English - 45