Factory Default Values; Multi-Room Functionality; Cleaning; Storage When Not In Use - Silvercrest SMRB 40 A1 Bedienungsanleitung

SilverCrest SMRB 40 A1

Factory default values

Proceed as follows to restore the factory default values:
Press and hold the WPS / RESET button for approx. 15 seconds. The sound bar will restart. After a
brief initialisation period (yellow and blue LEDs on simultaneously, then one LED briefly lights up
green) only the blue LED flashes slowly and the device is in AP mode.
Please note that all custom settings will be lost when restoring the factory default
values.
Restore the factory default values before passing on the sound bar so that your data
are not revealed to any third parties!

Multi-room functionality

A multi-room system is very versatile. If you have multiple Wi-Fi speakers, you can group them by
using the SilverCrest Smart-Audio app. For example, you can install one speaker per room, group
them and then use your smartphone or tablet PC for centralised control. For instance, if you select a
radio station, it will be played on all grouped speakers.
Of course, you can ungroup the devices at any time and then control each speaker individually.
Or you can create multiple small groups for individual control.
For more information, see the chapter "Setting up a group" on page 55.

Cleaning

Switch the device off and unplug the power adapter from the mains. To clean it, use a soft, dry
cloth. Never use any solvents or cleaners and never an abrasive sponge. Otherwise the sound bar
housing can be damaged.

Storage when not in use

If the device is not to be used for an extended period, store it in a clean, dry and
cool place. Also remove the batteries from the remote control to prevent any
leaking.
62 - English