Getting Started - REVELL Control THE BIG ONE Bedienungsanleitung

1. GETTING STARTED:

Before you start, make sure that the throttle stick (on the left of the controller) is in the down position to prevent
the helicopter from taking off unexpectedly. Move the controller's ON/OFF switch to "ON". Carefully connect the
two parts of the fl ight cable on the helicopter. Turn the helicopter's ON/OFF switch to "ON". Place the helicopter
on the fl oor at a distance of 1-2 metres with the tail pointing towards you. The controller needs around
5 seconds to synchronise with the helicopter. To start the helicopter, slowly move the throttle stick upwards
and set the trim dial to the lowest position.
2. TRIMMING THE CONTROLLER:
Taking time to adjust the trimming will ensure that the helicopter fl ies smoothly. It is easy to do, but does require a little patience and a light touch.
Please follow these instructions carefully: Slowly move the throttle stick up to raise the helicopter to a height of about 0.5 metres to 1 metre.
If the helicopter spirals
right or keeps turning
slowly to the right...
If the helicopter spirals right or keeps turning slowly to the right, turn the left and right
precision trim dial anti-clockwise until the helicopter stops turning.
The helicopter fl ies forwards
independently...
If the helicopter fl ies forwards independently, move the pitch trim dial downwards until the
helicopter no longer moves forwards.
The helicopter takes off
independently...
If the helicopter takes off independently, move the throttle trim dial downwards until the helicopter
no longer takes off.
8
Big_Heli_MHz_Anleitung_06.indd 8 Big_Heli_MHz_Anleitung_06.indd 8
Flying the Helicopter
Roll trim:
If the helicopter continues to drift to one side when fl ying, try to correct this by moving the roll trim dial in the opposite
direction to the way the helicopter is drifting.
If the helicopter spirals
left or keeps turning slowly
to the left...
If the helicopter spirals left or keeps turning slowly to the left, turn the left and right precision
trim dial clockwise until the helicopter stops turning.
The helicopter fl ies backwards
independently...
If the helicopter fl ies backwards independently, move the pitch trim dial upwards until the
helicopter no longer moves backwards.
The helicopter loses altitude
independently...
If the helicopter loses altitude independently, move the throttle trim dial upwards until the
helicopter no longer loses altitude.
Distance 2 m
26.02.10 10:58 26.02.10 10:58