Status Indicators - Honeywell UniVario FMX5000 UV.ESSER Bedienungs- Und Installationsanleitung

7.1

Status Indicators

The flame detector has one red and one two-colour, green/yellow status indicator.
Fig. 1: Status indicators

Operating (LED
This LED indicates two states:
In operational condition, the green LED blinks at 10-second intervals.

Fault (LED yellow)
• The green LED is not blinking.
• The yellow fault LED lights up when a detector zone is detected (error).
• The current to this detector zone increases by approx. 9 mA.
• The condition is not stored and the indicator remains active only for as long as the error is
present.
Exception: If the detector was operated for an extended period outside of the permissible
temperature range or faulty functioning of the DIL switch is detected, a constant error is
indicated.

Alarm (LED red)
• The red LED is lit.
• The current to this detector zone (alarm) increases by approx. 18,3 mA.
• Optionally, a parallel detector indicator (e.g. Part No. 801824) can be connected via a relay
of the esserbus ®
FB 798658 / 06.15
UV-Flame detector UniVario FMX5000 UV.ESSER
2
LED
LED
1
green)
transponder (Part No. 808623.10).
27