Honeywell UniVario FMX5000 UV.ESSER Bedienungs- Und Installationsanleitung Seite 24

UV-Flame detector UniVario FMX5000 UV.ESSER
Intended purpose
This product must only be used for the applications outlined in the catalogue and the
technical description. Only connect third-party equipment or components recommended by
the manufactures.
Warning
In order to ensure correct and safe operation of the product, all guidelines concerning its
transport, storage, installation, and mounting must be observed. This includes the
necessary care in operating the product.
Safety-relevant user information
This manual includes all information required for the proper use of the products described
here.
The term 'qualified personnel' in the context of the safety information included in this manual
or on the product itself designates:
• project engineers who are familiar with the safety guidelines concerning fire alarm and
extinguishing systems.
• trained service engineers who are familiar with the components of fire alarm and extinguishing
systems and the information on their operation as included in this manual.
• trained installation or service personnel with the necessary qualification for carrying out
repairs on fire alarm and extinguishing systems or who are authorised to operate, ground
and label electrical circuits and/or safety equipment/systems.
Safety warnings
The following information is given in the interest of your personal safety and to prevent
damage to the product described in this manual and all equipment connected to it.
Safety information and warnings for the prevention of dangers putting at risk the life and
health of user and maintenance personnel as well as causing damage to the equipment
itself are marked by the following pictograms. Within the context of this manual, these
pictograms have the following meanings:
Danger of death, severe injury or considerable material damage if the
relevant safety precautions are not observed.
Important information on the product or a particular section of this manual,
which should be read with particular attention.
§
Observe configuration and commissioning information in accordance to the
national and local requirements.
Dismantling
In accordance with Directive 2002/96/EG (WEEE), after being dismantled,
electrical and electronic equipment is taken back by the manufacturer for
proper disposal.
24
FB 798658 / 06.15