Decommissioning, Disassembly, Environmental Protection; Decommissioning; Dismantling - ECOLAB Turbo SMART II Betriebsanleitung

10

Decommissioning, disassembly, environmental protection

Personnel:
DANGER!
Risk of injury due to the disregard of the specified personal protective
equipment (PPE)!
For all disassembly work, please respect the use of the PSA which is specified
on the product data sheet.
10.1

Decommissioning

DANGER!
The procedures described here may only be carried out by skilled personnel as
described at the start of the chapter, this may only be done using PPE.
To take the equipment out of operation, proceed as follows:
1. Before carrying out any subsequent work, completely cut off the electrical supply first
and secure it against unintentional switch-on.
2. Relieve internal pressure of the pump and line pressure in the metering system.
3. Drain off metering medium from the entire system without leaving any residue.
4. Drain and remove operating and auxiliary materials.
5. Remove the remaining processing materials and dispose of them in an environment-
friendly way.
10.2

Dismantling

DANGER!
Dismantling may only be carried out by skilled personnel using PPE.
Before commencing dismantling, ensure that the device has been fully isolated
from the power supply. Contact with live components can be fatal. Activated
electrical components can make uncontrolled movements and lead to serious
injury.
Carefully rinse all components which come into contact with the product in
order to remove chemical residue.
WARNING!
Danger of injury in case of improper dismantling!
Stored residual energy, components with sharp edges, points and corners, on
and in the system, or on the required tools can cause injuries.
Decommissioning, disassembly, environmental protection
n Mechanic
n Qualified electrician
n Specialist
n Servicing personnel
45 Rev. 5-06.2018