ABB CoriolisMaster FCB100 Anweisung Seite 24

8 – EN CORIOLISMASTER FCX100, FCX400 SEALING OF DEVICES | IN/FCX100/FCX400/MID/OIML-XA REV. A
1
2
3
Fig. 11
4. Continue to twist the seal wire
hole screw 3 . Guide one end of the wire through the
hole in the screw, guide the other end near the screw.
Tightly twist the seal wire
screw 3 to secure the screw.
5. Continue to twist the seal wire
hole screw 2 . Secure the front head hole screw
described previously.
6. Tightly twist both ends of the seal wire after the front
head hole screw 2 over a length of approx. 5 cm.
7. Place the seal approx. 5 cm from the front head hole
screw 2 onto the ends of the seal wire and press
together using sealing pliers. Cut off any excess
wire.
G12354
1 up to the rear head
1 right behind the head hole
up to the front head
1
2
1
as
seal