5.3
Setting the crimping die size
►
Turn the lock (2) on the front flap (1) to
open it.
►
Swing the front flap (1) to the side.
A sticker is located on the inside of the
front flap with the setting values for the
crimping die.
1
Figure 5.2 Housing parts
Figure 5.3 Crimping die size sticker
34
2
Figure 5.4 Setting the die size
►
Press the drum (3) to the left and turn it
until it latches into the desired die size (4)
(see also Figure 5.3).
–
The currently set crimping die is
indicated using Roman numerals (I-III)
and parallel in the touch display.
►
Check that the drum is latched in properly
by attempting to turn it.
3
4
2516400000/01/03.2017