4 Transporting and setting up the machine
4.1
Installation location
The installation location must meet the following
requirements:
–
Stable foundation with straight, even surface
(for machine weight, see section 3.1).
–
Keep 30 cm work area free on both sides
and in front of the machine.
–
Electricity connection easily accessible close
by.
4.2
Transporting the machine
►
Always wear work shoes with
foot protection when
transporting the machine.
►
Empty the waste container prior to each
transport.
►
Note the weight of the machine
(see section 3.1).
Use a transport aid if necessary.
►
To move the machine, always lift it from the
base plate.
►
To prepare the machine for shipping
(e.g. in the event of servicing), use the
transport packaging.
32
4.3
Unpacking the delivery
►
Check the delivery for completeness
(for scope of delivery, see below).
►
Store away the transport packaging.
►
Ensure that the operating instructions are
accessible to the user at all times.
4.4
Scope of delivery
–
Stripping and crimping machine
– Mains connection cable (10 A, 250 V)
– Allen key size 4 (located in the machine)
– Operating Instructions
4.5
Establishing connections
►
Set up the machine in the intended
location.
►
Insert the power cable into the power
connection socket (Bild 3.2, 9) of the
machine and connect it up to the power
supply.
►
Switch on the Crimpfix E at the
On/Off switch (figures 3.2, 7).
2516400000/01/03.2017