General Safety Notes; Intended Use; Material That Can Be Processed And Crimping Shape; Safety Equipment - Weidmuller Crimpfix E Originalbetriebsanleitung

2 General safety notes

2.1

Intended use

The machine is intended for the stripping and
crimping of flexible wires in one work process.
Only the material described below may be
processed using the machine (wires and wire-
end ferrules).
Process-safe processing can only be
guaranteed for Weidmüller wire-end ferrules.
The processing of other makes may lead to
faults and damage to the machine.
The machine must only be used within the
technical limits described (see section 3.1).
Modifications to and reconstructions of the
machine must not be performed.
Intended use also includes paying attention to
the documentation.
2.2
Material that can be processed and
crimping shape
Wires
Flexible PVC cable H05V-K and H07V-K with
a cross section of 0.5–2.5 mm².
High-temperature resistant, halogen-free or
other specially produced insulating materials
of the same power types form the exceptions
here.
Wire-end ferrules (WEF)
Weidmüller-belted wire-end ferrules (WEF)
with plastic shroud:
H0.5/14; H0.75/14; H1.0/14; H1.5/14; H2.5/14
Crimp form
Trapezium
28
2.3

Safety equipment

The machine is equipped with the following
safety devices:
–
Safety switch inside on the front flap
–
Mains adapter
These items of safety equipment must not be
rendered ineffective. They must be checked
once per year by a service technician.
2.4

Personnel

Only trained personnel may operate the
machine and perform maintenance activities.
Training also includes having fully read the
operating instructions.
Repairs may only be performed
following consultation with
Weidmüller Service and only by
an electrical specialist.
Keep the operating instructions
stored so that they can be
inspected by operating personnel
at any time.
All documents can also be
downloaded from the Weidmüller
website.
2516400000/01/03.2017