Setting Up The Machine; Adjusting The Stripping Grade; Performing A Stripping Test - Weidmuller Crimpfix E Originalbetriebsanleitung

5 Setting up the machine

The machine has to be set up in the following
situations:
– If a different type of wire-end ferrule has to
be processed
– Every time the machine is put into operation
During set-up, the following settings must be
checked and adjusted if necessary:
–
Start position symbol
–
Stripping grade; wire cross section
–
Crimping drum
–
Day counter
To set the machine up, it must be in
the start position, and the start position
symbol must be displayed.
Basic menu display:
2.50 mm²
13 / 2.50 mm²
+1 21
A Crimping die size
B Stripping grade
C Wire cross section
D Day counter
E Start position symbol
Stripping grade adjustment value overview:
Table 2: Adjustment values
2516400000/01/03.2017
5.1
Required tool: Allen key size 4.
– The stripping grade (B) and the wire cross
– By turning in a clockwise/anti-clockwise
A
B / C
D E
Figure 5.1 Stripping grade adjustment
5.2
Each time the material to be processed is
changed, a stripping test must be conducted.
►
►
►
►
►

Adjusting the stripping grade

The stripping grade display on the touch
display is only possible when the front flap is
closed (Figure 3.2, 3).
section (C) are shown on the touch display.
direction, the stripping grade is altered.

Performing a stripping test

Switch on the mains switch.
There must be no more wire-end ferrules in
the transport unit.
Insert a wire for stripping.
Check the result:
–
Is all the stranded wire undamaged?
–
Has stripping been performed straight and
evenly?
Change the stripping grade if the result is
unsatisfactory and repeat the test.
33