Inching Mode - Weidmuller Crimpfix E Originalbetriebsanleitung

8.7

Inching mode

In inching mode, you can specifically move to
all processing positions of the machine.
Prerequisites:
–
Machine is in start position and is switched
on.
–
One of the stripping grades 1 to 15 must be
set.
►
Switch the machine off.
►
Open the front flap (Figure 3.1, 3).
►
Remove the wire-end ferrule belt.
►
Shut the front flap.
►
Keep the touch display pressed.
►
Switch on the machine.
 Machine is in inching mode and shows
the touch display "Inching mode start
position".
Touch panel display indicator
Inching mode
start position
Inching mode
Not start
position
Figure 8.7 Inching mode
The bottom part of the touch display
(Figure 3.1, 4) is touch-sensitive.
You can use the two arrow keys to move the
machine mechanism forwards and backwards.
48
Back to start position:
►
Move the machine mechanism by pressing
the arrow keys (3) forwards and backwards
until the start position (2) is reached.
Or:
►
Press on the hand symbol for 3 s (1).
The machine automatically moves to the
start position (B).
►
Switch the machine off.
►
Insert the wire-end ferrule belt.
►
Switch on the machine.
1
2
3
2516400000/01/03.2017