Process Of Crimping - Weidmuller 10/120 Serie Betriebs- Und Wartungsanleitung

3.3

Process of crimping

CAUTION
Attention: During the crimping process you are in danger of bruising
1 Open the crimping tool and put in the cable lug/connector at the lower bound of the
crimping dies (see the following drawing). Do not tilt the cable lug / connector. The
unit cable lug/cable should be right angled to the profile dies.
Figure 2 Schematic drawing of the crimping process
2 Close the tool a little bit until the cable lug is fixed.
3 Insert the stripped cable into the sleeve of the cable lug / connector.
4 Close the tool completely until the toggles are on top of each other (see Figure 1 on
page 25).
NOTICE
Attention, the tool has prestressing now. Open the tool when finishing the
crimping process.
1548670000/00/06.14
Operating
27