Inserting Wire-End Ferrules; Changing The Wire-End Ferrule Reel - Weidmuller Crimpfix E Originalbetriebsanleitung

5.4

Inserting wire-end ferrules

►
Set up the wire-end ferrule role (1) so that
clockwise unrolling is ensured.
►
Turn the lock (2) on the front flap (1) to
open it.
3
Figure 5.5 Positioning the wire-end ferrule
Figure 5.6 Threading wire-end ferrules into
the transport unit
2516400000/01/03.2017
The transport bolt (Figure 3.3, 2) in the
transport unit must be fully underneath.
See also the sticker on the transport unit.
The transport bolt is pressed downwards by
a spring.
If it is not fully down:
►
Check if the transport bolt is blocked, and
remove the block if necessary.
1
►
Push the wire-end ferrule belt into the
transport unit just until the lowest sheath
latches in.
►
Check for firm fitting by pulling the wire-end
ferrule belt carefully.
►
Close the front flap (2) using the front flap
2
lock (3).
►
Roll up the loose wire-end ferrule belt.
5.5
►
Turn the lock (2) on the front flap (1) to
open it.
►
Swing the front flap (2) to the side.
►
Press the transport bolt (Figure 3.3, 2) fully
upwards, and pull the wire-end ferrule belt
out of the transport unit.
►
See section 5.4.
There must be no sheaths protruding
downwards.

Changing the wire-end ferrule reel

35