Step-By-Step Instructions - DENTSPLY SmartLite FOCUS Gebrauchsanweisung

3

Step-by-step instructions

3.1 Installation and charging (
1. Remove floor panel
(see
Figure B2
2. Connect jack
3. Close floor panel (see
4. Make sure power socket used for power connector is accessible at all times in
case of necessary emergency disconnection.
5. Insert battery pack
(see
Figure A2
6. SmartLite FOCUS battery pack is pre-charged and ready to use upon purchase.
®
7. To recharge the battery, insert the handpiece
(see
3 Figure B5
recharging.
The SmartLite
erating time after 10 minutes recharging.
3.2 Operation
1. Protect LED tip from gross contamination by applying the single use SmartLite
Sleeves (see
2. Use the SmartLite
mounted SmartLite
Procedure D
SmartLite FOCUS to avoid accidental aspiration. Always make sure SmartLite
®
FOCUS Shields are properly mounted on SmartLite
light aperture (see
3. Adjust the LED tip: The LED tip is rotatable by 330°, thus the position of light
emission may be individually adjusted. The LED tip must be adjusted to an angle
that allows optimal curing of the restoration. The LED tip should be positioned as
closely as possible to the restoration and may even touch the restoration as
the LED tip is protected by the SmartLite
4. Polymerization: Briefly press the ON/OFF key [1.1.1 ON/OFF key]. Audible opera-
tion signals are described in [1.1.3 Audible signals].
5. To stop curing light before the end of the 20 second cycle, press ON/OFF key at
any time. To cure a restorative material that requires a curing time longer than
20 seconds, repeat activation by pressing the ON/OFF key after the end of each
20-second curing cycle (see also [2.2 Precautions]).
6. Curing times for a range of DENTSPLY materials are outlined in the Curing Guide
provided. When using other products, please refer to respective product's in-
structions for use.
Procedure A
of charging base by lifting floor panel at its back end
3.1
).
to charging base socket
4.1
Figure B4
into SmartLite
2
and
Figure A3
). The battery light will be flashing green, indicating battery is
FOCUS quick recharging mode allows a minimum of 5 minutes op-
®
).
Procedure C
FOCUS Shields supplied with the unit in combination with
®
Sleeves or use suitable, light filtering safety glasses (see
®
). Always make sure SmartLite
Figure D3
and
Procedure B
3.2
) and plug in power connector
FOCUS handpiece
®
).
FOCUS Shields are securely fixed to
®
and ).
Figure D4
Sleeves.
®
)
(see ).
Figure B3
.
4
1
into the charging base
1
FOCUS without covering the
®
®
®
6