Adverse Reactions; Step-By-Step Instructions - DENTSPLY x-smart plus Gebrauchsanleitung

• Recharge rechargeable battery after it depletes as much as possible. Repeating short-time
use and subsequent recharging may shorten its operating time due to the "memory effect."
The battery may recover after repeating complete discharge and full charge for a few times
(see chapter 6.9. Battery Refresh).
• The used Nickel Metal Hydride batteries are recyclable, but their disposal may sometimes
not be permitted by law in your location. Return them to your distributor.
• When disposing of the control unit, follow the instructions of your local government for
disposal, as they contain materials which may become industrial waste.
• When discarding the contra-angle and motor handpiece, dispose of them as medical
waste.
The manufacturer declines any responsibility in the case of:
• Use of the device for applications other than those specified in the instructions for use and
maintenance.
• Modifications or repairs performed by persons not authorized by the manufacturer.
• Use of non-original components or components other than those specified in the
STANDARD COMPONENTS chapter (see chapter 6.1).
• File breakage due to misuse.
• Accessories or device breakages due to sterilization: none of the X-SMART
components are sterilizable (except for the contra-angle).
5.

Adverse Reactions

There are no known adverse reactions.
6.

Step-by-Step Instructions

Refer to the WARNINGS chapter (see chapter 3) to verify any special care to exercise before
starting to use the complete device.
Before use, please check the exact contents of the package.
Ambient Conditions for Operation
- Use:
- Ambient temperature:
- Relative humidity:
- Atmospheric pressure:
- The original packing materials may be stored and shipped in ambient conditions of
-10°C to + 50°C (from 14°F to 122°F) with relative humidity at 10% - 85% and
atmospheric pressure at 500hPa to 1060hPa.
WARNING
Do not install the device in damp places or in places where it will come into constant contact
with liquids of any kind.
FISDR-JAP / F1902124.X / 00 / 2011 – created 07/2011
indoor
10°C – 40°C (50°F – 104°F)
30% – 75%
700hPa – 1060hPa
Plus
™
- 11 / 208 -