Denon AVC-A11SR Bedienungsanleitung Seite 29

Surround parameters q
DECODER:
Select the decoder to be used when playing 2-channel sources in the Home THX Cinema mode.
PL II C........The signals are decoded in the Dolby Pro Logic II Cinema mode before undergoing THX
processing.
PL II E........The signals are decoded in the Dolby Pro Logic emulation mode before undergoing THX
processing.
NEO:6 C ....The signals are decoded in the NEO:6 Cinema mode before undergoing THX processing.
AFDM (Auto Flag Detect Mode):
Select the Auto Flag Detect Mode. (See page 12.)
SB CH OUT:
When Auto Flag Detect Mode is set to "OFF", the reproduction method of a surround back channel can be
chosen.
The parameter which can be chosen is equivalent to the contents of a setting of Non Flag Source SBch
Output (see page 12).
When Auto Flag Detect Mode is set to "ON", the parameter selected by Non Flag Source SBch Output of
Setup Menu is displayed (see page 12).
When you change a parameter, please set Auto Flag Detect Mode to OFF.
[2] To play in the THX Surround EX/Home THX Cinema Surround mode for sources
recorded in Dolby Digital or DTS
1
Select the program source.
Selecting a digital input source
Perform step 1 under "Dolby Digital mode and
DTS Surround" (page 30).
2
Select the Home THX Cinema mode.
HOME
THX CINEMA
(Main unit) (Remote control unit)
3
Play a program source with the
mark.
For operating instructions, refer to the manuals
of the respective components.
The channel status information during playback
of Dolby Digital and DTS sources can be
checked using the "STATUS" button on the
main unit.
The surround back indicator lights
OUTPUT
green when playing in the THX
SURROUND EX mode.
The Dolby Digital indicator lights when
DIGITAL
playing Dolby Digital sources.
When playing DTS sources, the DTS
indicator lights.
3 3
2 3
,
2
Checking the input signal
The input signal can be checked by pressing the remote
control unit's OSD button. (See page 24.)
SIGNAL: Displays the type of signal (DTS, DOLBY
DIGITAL, PCM, etc.).
fs: Displays the input signal's sampling frequency.
FORMAT: Displays the input signal's number of channels.
"Number of front channels/Number
surround channels/LFE on/off"
"SURROUND" is displayed for 2-channel signal sources
recorded in Dolby Surround.
OFFSET: Displays the dialog normalization offset value. (See page 30.)
FLAG: Displays the special identification signal recorded in the input
signal. (See page 12.)
"MATRIX" is displayed when matrix processing is conducted
on the surround back channel, "DISCRETE" is displayed when
discrete processing is conducted.
Not displayed when no identification signal is recorded.
In addition, screen information is displayed in the following order when the OSD button is pressed
repeatedly:
OSD-1 Input signal
OSD-2 Input/output
OSD-3 Surround parameter
OSD-4 Tone control
OSD-5 Surround mode
OSD-6 Surround mode
OSD-7 Digital in assignment
NOTE:
OSD-3: Not displayed in surround modes without surround parameters.
OSD-4: Not displayed in surround modes in which the tone cannot be controlled.
ENGLISH
(Remote control unit)
of
29