Denon AVC-A11SR Bedienungsanleitung Seite 20

ENGLISH
System call
The included remote control unit is equipped with a system call function allowing a series of remote control
signals to be transmitted by pressing a single button.
This function can be used for example to turn on the amplifier's power, select the input source, turn on the
monitor TV's power, turn on the source component's power and set the source to the play mode, all at the touch
of a button.
(1) System call buttons
System call signals can be stored at the CALL 1 and CALL 2
buttons.
29 successive operations can be set at each of these buttons.
(2) Storing system call signals
1
Press the power ON/SOURCE button and the OFF button at
the same time. "SET UP" appears on the remote control
unit's display.
ON /
OFF
SOURCE
2
Press the ENTER button.
ENTER / SH FT
SELEC
3 Use the D and H cursor buttons to display "SYS CALL" on
the remote control unit, then press the ENTER button.
• Display "SYSCALL1" on the remote control unit's display.
TUNING
ENTER / SH FT
BAN MODE
SELEC
TUNIN
4 When "SYSCALL1" is displayed, the remote control unit's
display switches as shown below each time the D and H
cursor buttons are pressed.
TUNING
BAND MODE SYSCALL 1 SYSCALL 2
TUNING
When "SYSCALL1" or "SYSCALL2" is selected, the signals
are stored at the SYSTEM CALL 1 and CALL 2 buttons
(green), regardless of the mode. When the enter button is
pressed "ENTER KEYS" is displayed, then the mode display
appears.
20
5 q Press the mode selector button according to
w Press the buttons with the remote control
NOTES:
• The remote control signals of the buttons pressed while registering the system call signals are emitted, so
be careful not to operate the components accidentally (cover the remote sensors, for example).
• If you exceed the number of signals that can be registered, "FULL" appears on the remote control unit's
display and only the number of signals that can be registered are registered (up to 29 operations).
(3) Using the system call function
1
1 Press the button at which the system call signals have been stored.
• The stored signals are transmitted successively.
5
3, 4
Resetting
2, 3, 6
(1) Resetting the system call buttons
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "SET UP" appears on the remote control
unit's display.
2
ENTER / SHIFT
3
Use the D and H cursor buttons to display
"RESET" on the remote control unit, then press
the ENTER button.
BAND
6
the button with the remote control signals to
be registered.
signals to be registered one at a time.
ON /
OFF
SOURCE
Press the ENTER button.
SELEC
UNING
ENTER / SHIFT
MODE
SELEC
TUNING
Press the ENTER button.
ENTER / SHIFT
• "COMPLETE" appears on the
SELEC
remote control unit's display and
registration is completed.
1
3, 4, 5
2, 3, 4, 5, 6