Denon AVC-A11SR Bedienungsanleitung Seite 13

3
Select the desired unit, meters or feet.
UNING
Select (darken) the desired units, "Meters" or "Feet".
BAND M E
TUNING
4
Once "Meters" or "Feet" is selected in Step 3,
the Delay Time screen appears automatically.
5
At the System Setup Menu select "Delay Time".
TUNING
BAND MODE
TUNING
6
Set the distance between the
TUNING
center speaker and listening
position.
BAND M E
The distance changes in units
TUNING
of 0.1 meters each time the
button is pressed. Select the
value closest to the measured
distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
Please note that the difference of distance for every speaker
should be 4.5 m or less. If you set an invalid distance, a
CAUTION notice, such as screen right will appear. In this
case, please relocate the blinking speaker(s) so that its
distance is no larger than the value shown in highlighted line.
7
Enter the setting.
ENTER / SHIFT
The System Setup Menu reappears.
SELEC
The AVC-A11SR automatically sets the optimum surround delay time for the listening
room.
Example: When "Meters" is selected
Example: When the distance is set to 3 6 m for the center speaker
Setting the Multi Zone Vol.Level
Multi-zone is a pre-output with an output level adjustment function.
1
At the System Setup Menu, select "Multi Zone Vol.Level".
UNING
BAND MODE
TUNING
2
Press the ENTER button to switch to the "Multi Zone Vol.
ENTER / SHIFT
Level" screen.
SELEC
3
Select the desired setting.
TUN NG
BAND M E
TUN NG
Variable:
The level can be adjusted freely using the buttons on the remote control
unit.
q Select "MULTI" display using the AMP button.
w Press the VOLUME + (up) and - (down) buttons to adjust the output
level.
-40 dB, 0 dB:
The output level is fixed at the set level and the volume can no longer be
adjusted.
4
Enter the setting.
ENTER / SHIFT
The System Setup Menu reappears.
SELEC
ENGLISH
MULTI
q
w
13