Charging The Battery Pack; Checking The Battery Level; Attaching / Removing The Auxiliary Handle; Adjusting The Guard - Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Removing the battery pack:
1. Press the release button
battery pack .
4

Charging the battery pack

Q
NOTE
The battery pack
u
Charge the battery pack
ideally at least 90 minutes.
Always pull out the plug of the charger
u
from the mains before removing or connecting
the battery pack
4
Never charge the battery pack
u
the ambient temperature is below 10 °C or
above 40 °C.
Rest the charger
13
u
between successive charging sessions.
If no battery pack
u
charger and the charger is connected to
13
mains, the charging status LED
green.
1. Connect the battery pack
charger .
13
2. Insert the mains plug into the socket. The
charging status LED
Once the battery pack
charged, the green charging status LED
indicates that the charging process is complete.
3. Disconnect the charger
and remove the battery pack
charger.
4. Attach the battery pack
Charging status LEDs
Green LED lights up
without battery pack
Green LED lights up
with battery pack
Red LED lights up
with battery pack
Red LED flashes with
battery pack
Green LED flashes
with battery pack

Checking the battery level

Q
Press the battery level button
o
charging level of the battery pack
charging level will be shown on the battery
level indication light
14 GB
and remove the
2
comes partly charged.
4
prior to first use,
4
13
to the charger.
when
4
for at least 15 minutes
is inserted into the
4
lights up
15
to the battery
4
lights up red.
14
is completely
4
15
from the mains
13
from the
4
back to the product.
4
Charger ready
Battery pack fully charged
Battery pack charging
Battery pack defect
Battery pack too cold or
warm
to check the
1
4 . The
.
3
3 Red LEDs light up
2 Red LEDs light up
1 Red LEDs lights up low charging level
Charge the battery pack
o
when it is at medium or low charging level.
Attaching / removing the
Q
auxiliary handle
NOTE
The product must only be operated with the
u
auxiliary handle mounted.
1. Screw the auxiliary handle
on the type of work, to the left, right or top of
the product using the threads for the auxiliary
handle .
11

Adjusting the guard

Q
WARNING!
Always remove the battery pack from the
u
product before adjusting the guard in order
to avoid switching it on accidentally.
CAUTION! RISK OF INJURY!
Wear protective gloves. Be careful when
u
gripping and turning the guard due to
potential finger squeezing hazard between
the guard and disc.
NOTE
The product must only be operated with the
u
guard mounted.
maximum charging level
medium charging level
before operation
4
6 , depending