Angle Grinder Warnings - Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Disconnect the plug from the power
3.
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting the
power tool accidentally.
Store idle power tools out of the
4.
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for
5.
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean.
6.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
Use the power tool, accessories
7.
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Battery tool use and care
Recharge only with the charger
1.
specified by the manufacturer. A
charger that is suitable for one type of battery
pack may create a risk of fire when used with
another battery pack.
Use power tools only with
2.
specifically designated battery
packs. Use of any other battery packs may
create a risk of injury and fire.
When battery pack is not in use,
3.
keep it away from other metal
objects, like paper clips, coins, keys,
nails, screws or other small metal
objects, that can make a connection
from one terminal to another. Shorting
the battery terminals together may cause
burns or a fire.
Under abusive conditions, liquid
4.
may be ejected from the battery;
avoid contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
Service
Have your power tool serviced by
1.
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.

Angle grinder warnings

Q
Safety warnings common for grinding
and wire brushing operations:
This power tool is intended to
1.
function as a grinder and wire
brush. Read all safety warnings,
instructions, illustrations and
specifications provided with this
power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury.
Operations such as sanding,
2.
polishing or cutting-off are not
recommended to be performed with
this power tool. Operations for which the
power tool was not designed may create a
hazard and cause personal injury.
Do not use accessories which
3.
are not specifically designed
and recommended by the tool
manufacturer. Just because the accessory
can be attached to your power tool, it does
not assure safe operation.
The rated speed of the accessory
4.
must be at least equal to the
maximum speed marked on the
power tool. Accessories running faster than
their rated speed can break and fly apart.
The outside diameter and the
5.
thickness of your accessory must be
within the capacity rating of your
power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
Threaded mounting of accessories
6.
must match the grinder spindle
thread. For accessories mounted
by flanges, the arbour size hole of
the accessory must fit the locating
diameter of the flange. Accessories that
do not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
GB 9